-- Example Yoink Configuration File

print "loading default settings..."


-- Set the level of detail to use when drawing scenes.  This can be 1, 2 or 3,
-- where 1 shows the least amount of detail and 3 draws the scene with the
-- most detail.  Lower levels of detail may improve performance on slower
-- machines.

detail		= 3

-- Set the number of times each second the physics state will be updated.  The
-- quality of the physics simulation will increase as you increase this value,
-- but the processor will be taxed more.  Errors could be introduced in the
-- game with extremely low values.

timestep	= 100

-- Set the target number of frames that should be drawn per second.  The
-- smoothness of the animation increases as you increase this value.  You
-- probably want to set this somewhere in the 25-200 range, depending on how
-- much work you want your computer to do.  For example, if you're on battery
-- power, you might prefer 25 which is still reasonably smooth and will
-- decrease battery drain significantly.  You can also set this to an
-- arbitrarily high number to effectively draw as many frames as possible, but
-- your actual framerate might be limited by the refresh rate of your display;
-- use the swapcontrol setting to enable or disable this behavior.  You can
-- determine your actual framerate with the showfps option.

framerate	= 60

-- Set this to show the current frames per second in the window caption.

showfps		= false

-- Set this to run the game in full-screen mode.  The default behavior is to
-- run the game in a window.

fullscreen	= false

-- If the game is running in a window, set this to also make the window
-- resizable.  This has no effective if the fullscreen option is set.

resizable	= true

-- Set the display resolution or size of the viewing window.  If left at the
-- default value (a function), the video mode will only be set if we're not in
-- fullscreen.  That way, a native resolution will be used.

videomode	= function()
	if not fullscreen then return {800, 600} end
end

-- Set this to use double-buffering to improve animation quality.  You really
-- don't want to turn this off.

doublebuffer	= true

-- Set this to sync with the refresh rate of your display.  Your framerate
-- will be limited to the refresh rate, but you may experience less tearing
-- caused by the display vertical refresh.  On the other hand, you might
-- experience worse tearing, depending on your setup.  Try it both ways.

swapcontrol	= false

-- Set this to the number of FSAA samples to perform.  This will smooth out
-- jagged lines but may reduce framerates on slow hardware.  Possible values
-- depend on your video card and drivers, but typical values include 1, 2, 4,
-- and higher powers of two.  Set to 0 to disable FSAA.

multisamples	= 0

-- Set the level of log detail that will be output to the console.  Possible
-- values are:
--   0 nothing
--   1 errors
--   2 warnings
--   3 info
--   4 debug messages

loglevel	= 2


-- vi:ft=lua